OVMS3/Reference/ZOE_Ph2/MIU_Tests.csv

1	00	Device and failure type ODB codding
2	01	General Electrical Failure
3	02	General signal failure
4	03	FM / PWM (Pulse Width Modulated) Failures
5	04	System Internal Failures
6	05	System Programming Failures
7	06	Algorithm Based Failures
8	07	Mechanical Failures
9	08	Bus Signal / Message Failures
10	09	Component Failures
11	11	circuit short to ground
12	12	circuit short to battery
13	13	circuit open
14	14	circuit short to ground or open
15	15	circuit short to battery or open
16	16	circuit voltage below threshold
17	17	circuit voltage above threshold
18	18	circuit current below threshold
19	19	circuit current above threshold
20	1A	circuit resistance below threshold
21	1B	circuit resistance above threshold
22	1C	circuit voltage out of range
23	1D	circuit current out of range
24	1E	circuit resistance out of range
25	1F	circuit intermittent
26	21	signal amplitude < minimum
27	22	signal amplitude > maximum
28	23	signal stuck low
29	24	signal stuck high
30	25	signal shape / waveform failure
31	26	signal rate of change below threshold
32	27	signal rate of change above threshold
33	28	signal bias level out of range / zero adj. failure
34	29	signal signal invalid
35	2F	signal erratic
36	31	no signal
37	32	signal low time < minimum
38	33	signal low time > maximum
39	34	signal high time < minimum
40	35	signal high time > maximum
41	36	signal frequency too low
42	37	signal frequency too high
43	38	signal frequency incorrect
44	39	incorrect has too few pulses
45	3A	incorrect has too many pulses
46	41	general checksum failure
47	42	general memory failure
48	43	special memory failure
49	44	data memory failure
50	45	program memory failure
51	46	calibration / parameter memory failure
52	47	watchdog / safety µC failure
53	48	supervision software failure
54	49	internal electronic failure
55	4A	incorrect component installed
56	4B	over temperature
57	51	not programmed
58	52	not activated
59	53	deactivated
60	54	missing calibration
61	55	not configured
62	61	signal calculation failure
63	62	signal compare failure
64	63	circuit / component protection time-out
65	64	signal plausibility failure
66	65	signal has too few transitions / events
67	66	signal has too many transitions / events
68	67	signal incorrect after event
69	68	event information
70	71	actuator stuck
71	72	actuator stuck open
72	73	actuator stuck closed
73	74	actuator slipping
74	75	emergency position not reachable
75	76	wrong mounting position
76	77	commanded position not reachable
77	78	alignment or adjustment incorrect
78	79	mechanical linkage failure
79	7A	fluid leak or seal failure
80	7B	low fluid level
81	81	invalid serial data received
82	82	alive / sequence counter incorrect / not updated
83	83	value of signal protection calculation incorrect
84	84	signal below allowable range
85	85	signal above allowable range
86	86	signal invalid
87	87	missing message
88	88	bus off
89	8F	erratic
90	91	parametric
91	92	performance or incorrect operation
92	93	no operation
93	94	unexpected operation
94	95	incorrect assembly
95	96	component internal failure
96	97	Component or sys. operation obstructed or blocked
97	98	component or system over temperature