1. Name change from chopper to carrier, block diagram update, minor changes to example codes 2. mcpwm_reg.h changed, brought uniformity in comments, worked on suggestions, duty to accept float. Some name changes! 3. Minor readme changes and Indetation 4. Minor change: move mcpwm_reg.h and mcpwm_struct.h to new path 5. Minor change: addition of BLDC example code and Readme 6. Name changed from epwm to mcpwm 7. Improve the reg name in mcpwm_struct.h 8. Name change chopper>carrier, deadband>deadtime
43 lines
1.8 KiB
Markdown
43 lines
1.8 KiB
Markdown
# MCPWM BLDC motor control(hall sensor feedback) Example
|
|
|
|
This example will show you how to use MCPWM module to control bldc motor with hall sensor feedback
|
|
|
|
The following examples uses MCPWM module to control bldc motor and vary its speed continuously
|
|
|
|
The bldc motor used for testing this code had hall sensor capture sequence of 6-->4-->5-->1-->3-->2-->6-->4--> and so on
|
|
|
|
IR2136 3-ph bridge driver is used for testing this example code
|
|
|
|
User needs to make changes according to the motor and gate driver ic used
|
|
|
|
|
|
## Step 1: Pin assignment
|
|
* The gpio init function initializes:
|
|
* GPIO15 is assigned as the MCPWM signal for 1H(UH)
|
|
* GPIO02 is assigned as the MCPWM signal for 1L(UL)
|
|
* GPIO00 is assigned as the MCPWM signal for 2H(VH)
|
|
* GPIO04 is assigned as the MCPWM signal for 2L(VL)
|
|
* GPIO16 is assigned as the MCPWM signal for 3H(WH)
|
|
* GPIO17 is assigned as the MCPWM signal for 3L(WL)
|
|
* GPIO25 is assigned as the MCPWM capture signal for Hall A
|
|
* GPIO26 is assigned as the MCPWM capture signal for HALL B
|
|
* GPIO27 is assigned as the MCPWM capture signal for HALL C
|
|
|
|
|
|
## Step 2: Connection
|
|
* Connect GPIO15 with 1H/UH of BLDC motor driver
|
|
* Connect GPIO02 with 1L/UL of BLDC motor driver
|
|
* Connect GPIO00 with 2H/VH of BLDC motor driver
|
|
* Connect GPIO04 with 2L/VL of BLDC motor driver
|
|
* Connect GPIO16 with 3H/WH of BLDC motor driver
|
|
* Connect GPIO17 with 3L/WL of BLDC motor driver
|
|
* Connect GPIO25 to hall sensor A output
|
|
* Connect GPIO26 to hall sensor B output
|
|
* Connect GPIO27 to hall sensor C output
|
|
|
|
|
|
## Step 3: Initialize MCPWM
|
|
* You need to set the frequency and duty cycle of MCPWM timer
|
|
* You need to set the MCPWM channel you want to use, and bind the channel with one of the timers
|
|
* You need to set the capture unit, for POS/NEG edge capture
|
|
* Also reversing the hall sensor BIT weight, will make bldc motor rotate CW or CCW
|