OVMS3-idf/examples/peripherals/rmt_tx/README.md

67 lines
2.1 KiB
Markdown
Raw Normal View History

2018-07-15 04:56:23 +00:00
# _RMT Transmit Example_
2017-11-20 03:51:30 +00:00
(See the README.md file in the upper level 'examples' directory for more information about examples.)
2017-11-20 03:51:30 +00:00
This example will shows how to configure and operate the remote control (RMT) peripheral to transmit a sample message in the [Morse code](https://en.wikipedia.org/wiki/Morse_code), it also shows how to transmit custom format of data.
2017-11-20 03:51:30 +00:00
## How to Use Example
### Hardware Required
2018-07-15 04:56:23 +00:00
* A development board with ESP32 SoC (e.g., ESP32-DevKitC, ESP-WORVER-KIT, etc.)
* A USB cable for Power supply and programming
* A LED, a speaker or an earphone
Connection :
```
330R LED
GPIO18 +----/\/\/\----+------|>|-----+ GND
|
| /|
+-+ | Speaker
| | | or
+-+ | earphone
| \|
|
+--------------+ GND
```
### Configure the Project
```
make menuconfig
```
* Set serial port under Serial Flasher Options.
### Build and Flash
Build the project and flash it to the board, then run monitor tool to view serial output:
```
make -j4 flash monitor
```
(To exit the serial monitor, type ``Ctrl-]``.)
See the [Getting Started Guide](https://docs.espressif.com/projects/esp-idf/en/latest/get-started/index.html) for full steps to configure and use ESP-IDF to build projects.
## Example Output
To be able to see and hear the message output by the RMT, connect a LED and a speaker or an earphone (be careful - it may be loud) to the GPIO18(the pin can be changed by modify the definition of `RMT_TX_GPIO` in `main/rmt_tx_main.c`).
2017-11-20 03:51:30 +00:00
Run this example, you will see the following output log:
```
RMT Tx: Transmission complete
RMT Tx: Sample transmission complete
```
## Troubleshooting
* Programming fail
2018-07-15 04:56:23 +00:00
* Hardware connection is not correct: run `make monitor`, and reboot your board to see if there is any output logs.
* The baud rate for downloading is too high: lower your baud rate in the `menuconfig` menu, and try again.
2017-11-20 03:51:30 +00:00
2018-07-15 04:56:23 +00:00
For any technical queries, please open an [issue] (https://github.com/espressif/esp-idf/issues) on GitHub. We will get back to you soon.