Notify about health state ========================= [◀ Go back to main README](../README.md) 🛈 This script can not be used on its own but requires the base installation. See [main README](../README.md) for details. Description ----------- This script is run from scheduler periodically, sending notification on health related events: * voltage jumps up or down more than configured threshold * power supply failed or recovered * temperature is above or below threshold Note that bad initial state will not trigger an event. Only sensors available in hardware can be checked. See what your hardware supports: / system health print; Requirements and installation ----------------------------- Just install the script and create a scheduler: $ScriptInstallUpdate check-health; / system scheduler add interval=1m name=check-health on-event="/ system script run check-health;" start-time=startup; Configuration ------------- The configuration goes to `global-config-overlay`, these are the parameters: * `CheckHealthTemperature`: an array specifying temperature thresholds for sensors * `CheckHealthVoltagePercent`: percentage value to trigger voltage jumps Also notification settings are required for e-mail, matrix and/or telegram. --- [◀ Go back to main README](../README.md) [▲ Go back to top](#top)