Notify about health state ========================= [⬅️ Go back to main README](../README.md) > ℹ️ **Info**: This script can not be used on its own but requires the base > installation. See [main README](../README.md) for details. Description ----------- This script is run from scheduler periodically, sending notification on health related events: * voltage jumps up or down more than configured threshold or drops below limit * power supply failed or recovered * temperature is above or below threshold Note that bad initial state will not trigger an event. Only sensors available in hardware can be checked. See what your hardware supports: /system/health/print; ### Sample notifications #### Voltage ![check-health notification voltage](check-health.d/notification-01-voltage.avif) #### Temperature ![check-health notification](check-health.d/notification-02-temperature-high.avif) ![check-health notification](check-health.d/notification-03-temperature-ok.avif) #### PSU state ![check-health notification](check-health.d/notification-04-psu-fail.avif) ![check-health notification](check-health.d/notification-05-psu-ok.avif) Requirements and installation ----------------------------- Just install the script and create a scheduler: $ScriptInstallUpdate check-health; /system/scheduler/add interval=1m name=check-health on-event="/system/script/run check-health;" start-time=startup; Configuration ------------- The configuration goes to `global-config-overlay`, these are the parameters: * `CheckHealthTemperature`: an array specifying temperature thresholds for sensors * `CheckHealthVoltageLow`: value (in volt*10) giving a hard lower limit * `CheckHealthVoltagePercent`: percentage value to trigger voltage jumps Also notification settings are required for [e-mail](mod/notification-email.md), [matrix](mod/notification-matrix.md) and/or [telegram](mod/notification-telegram.md). --- [⬅️ Go back to main README](../README.md) [⬆️ Go back to top](#top)