1. Bootloader reads SPI configuration from bin header, so that the burning configuration can be different with compiling configuration. 2. Psram mode init will overwrite original flash speed mode, so that users can change psram and flash speed after OTA. 3. Flash read mode(QIO/DIO…) will not be changed in app bin. It is decided by bootloader, OTA can not change this mode. 4. Add read flash ID function, and save flash ID in g_rom_flashchip 5. Set drive ability for all related GPIOs 6. Check raise VDDSDIO voltage in 80Mhz mode 7. Add check flash ID and update settings in bootloader 8. Read flash ID once and keep in global variable 9. Read flash image header once and reuse the result Tested cases: 1. Test new and old version of bootloader boot Flash 20M —> app Flash 80M + Psram 80M boot Flash 40M —> app Flash 80M + Psram 80M boot Flash 80M —> app Flash 80M + Psram 80M boot Flash 20M —> app Flash 80M + Psram 40M boot Flash 40M —> app Flash 80M + Psram 40M boot Flash 80M —> app Flash 80M + Psram 40M boot Flash 20M —> app Flash 40M + Psram 40M boot Flash 40M —> app Flash 40M + Psram 40M boot Flash 80M —> app Flash 40M + Psram 40M 2. Working after esp_restart reboot.
37 lines
1.1 KiB
C
37 lines
1.1 KiB
C
// Copyright 2015-2016 Espressif Systems (Shanghai) PTE LTD
|
|
//
|
|
// Licensed under the Apache License, Version 2.0 (the "License");
|
|
// you may not use this file except in compliance with the License.
|
|
// You may obtain a copy of the License at
|
|
|
|
// http://www.apache.org/licenses/LICENSE-2.0
|
|
//
|
|
// Unless required by applicable law or agreed to in writing, software
|
|
// distributed under the License is distributed on an "AS IS" BASIS,
|
|
// WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
|
|
// See the License for the specific language governing permissions and
|
|
// limitations under the License.
|
|
#pragma once
|
|
|
|
#ifdef __cplusplus
|
|
extern "C" {
|
|
#endif
|
|
|
|
/** @brief Enable Quad I/O mode in bootloader (if configured)
|
|
*
|
|
* Queries attached SPI flash ID and sends correct SPI flash
|
|
* commands to enable QIO or QOUT mode, then enables this mode.
|
|
*/
|
|
void bootloader_enable_qio_mode(void);
|
|
|
|
/**
|
|
* @brief Read flash ID by sending 0x9F command
|
|
* @return flash raw ID
|
|
* mfg_id = (ID >> 16) & 0xFF;
|
|
flash_id = ID & 0xffff;
|
|
*/
|
|
uint32_t bootloader_read_flash_id();
|
|
|
|
#ifdef __cplusplus
|
|
}
|
|
#endif
|