OVMS3-idf/components/ethernet/include/eth_phy/phy_tlk110.h
morris 18cb87b4ce ethernet: support new PHY (IP101)
1. Add support for new PHY IP101.
2. Re-enable GPIO0 output mode.
3. Clean up some docs.
2019-01-31 15:02:45 +08:00

75 lines
1.7 KiB
C

// Copyright 2015-2017 Espressif Systems (Shanghai) PTE LTD
//
// Licensed under the Apache License, Version 2.0 (the "License");
// you may not use this file except in compliance with the License.
// You may obtain a copy of the License at
// http://www.apache.org/licenses/LICENSE-2.0
//
// Unless required by applicable law or agreed to in writing, software
// distributed under the License is distributed on an "AS IS" BASIS,
// WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
// See the License for the specific language governing permissions and
// limitations under the License.
#pragma once
#ifdef __cplusplus
extern "C" {
#endif
#include "phy.h"
/**
* @brief Dump TLK110 PHY SMI configuration registers
*
*/
void phy_tlk110_dump_registers();
/**
* @brief Default TLK110 phy_check_init function
*
*/
void phy_tlk110_check_phy_init(void);
/**
* @brief Default TLK110 phy_get_speed_mode function
*
* @return eth_speed_mode_t Ethernet speed mode
*/
eth_speed_mode_t phy_tlk110_get_speed_mode(void);
/**
* @brief Default TLK110 phy_get_duplex_mode function
*
* @return eth_duplex_mode_t Ethernet duplex mode
*/
eth_duplex_mode_t phy_tlk110_get_duplex_mode(void);
/**
* @brief Default TLK110 phy_power_enable function
*
*/
void phy_tlk110_power_enable(bool);
/**
* @brief Default TLK110 phy_init function
*
* @return esp_err_t
* - ESP_OK on success
* - ESP_FAIL on error
*/
esp_err_t phy_tlk110_init(void);
/**
* @brief Default TLK110 PHY configuration
*
* @note This configuration is not suitable for use as-is,
* it will need to be modified for your particular PHY hardware setup.
*
*/
extern const eth_config_t phy_tlk110_default_ethernet_config;
#ifdef __cplusplus
}
#endif