bea507378e
1. components/nvs_flash/nvs_partition_generator/README_CN.rst 2. components/wear_levelling/README_CN.rst 3. tools/mass_mfg/docs/README_CN.rst
49 lines
2.6 KiB
ReStructuredText
49 lines
2.6 KiB
ReStructuredText
Wear Levelling API
|
|
==================
|
|
|
|
:link_to_translation:`zh_CN:[中文]`
|
|
|
|
Overview
|
|
--------
|
|
Most of flash memory and especially SPI flash that is used in ESP32 has a sector-based organization and also has a limited number of erase/modification cycles per memory sector. The wear levelling component helps to distribute wear and tear among sectors more evenly without requiring any attention from the user.
|
|
|
|
The wear levelling component provides API functions related to reading, writing, erasing, and memory mapping of data in external SPI flash through the partition component. The component also has higher-level API functions which work with the FAT filesystem defined in :doc:`FAT filesystem </api-reference/storage/fatfs>`.
|
|
|
|
The wear levelling component, together with the FAT FS component, uses FAT FS sectors of 4096 bytes, which is a standard size for flash memory. With this size, the component shows the best performance but needs additional memory in RAM.
|
|
|
|
To save internal memory, the component has two additional modes which both use sectors of 512 bytes:
|
|
|
|
- **Performance mode.** Erase sector operation data is stored in RAM, the sector is erased, and then data is copied back to flash memory. However, if a device is powered off for any reason, all 4096 bytes of data is lost.
|
|
- **Safety mode.** The data is first saved to flash memory, and after the sector is erased, the data is saved back. If a device is powered off, the data can be recovered as soon as the device boots up.
|
|
|
|
The default settings are as follows:
|
|
- Sector size is 512 bytes
|
|
- Performance mode
|
|
|
|
You can change the settings through the configuration menu.
|
|
|
|
|
|
The wear levelling component does not cache data in RAM. The write and erase functions modify flash directly, and flash contents are consistent when the function returns.
|
|
|
|
|
|
Wear Levelling access API functions
|
|
-----------------------------------
|
|
|
|
This is the set of API functions for working with data in flash:
|
|
|
|
- ``wl_mount`` - initializes the wear levelling module and mounts the specified partition
|
|
- ``wl_unmount`` - unmounts the partition and deinitializes the wear levelling module
|
|
- ``wl_erase_range`` - erases a range of addresses in flash
|
|
- ``wl_write`` - writes data to a partition
|
|
- ``wl_read`` - reads data from a partition
|
|
- ``wl_size`` - returns the size of available memory in bytes
|
|
- ``wl_sector_size`` - returns the size of one sector
|
|
|
|
As a rule, try to avoid using raw wear levelling functions and use filesystem-specific functions instead.
|
|
|
|
|
|
Memory Size
|
|
-----------
|
|
|
|
The memory size is calculated in the wear levelling module based on partition parameters. The module uses some sectors of flash for internal data.
|
|
|