History

Ivan Grokhotkov c2e424e7af ulp: fix calculation or ulp_run argument The argument to ulp_run should be expressed in 32-bit words. Both the address of ulp_entry and RTC_SLOW_MEM already are uint32_t*, so their difference is the difference in addresses divided by sizeof(uint32_t). Therefore the extra division by sizeof(uint32_t) is not needed.		2018-08-13 23:23:54 +03:00
..
main	ulp: fix calculation or ulp_run argument	2018-08-13 23:23:54 +03:00
Makefile	examples: add ULP ADC example	2017-05-16 13:15:02 +08:00
README.md	examples/ulp: disable pullup on GPIO15 to reduce current	2017-11-03 18:56:31 +08:00
sdkconfig.defaults	sdkconfig: set CONFIG_ESP32_DEEP_SLEEP_WAKEUP_DELAY=2000 by default	2017-05-25 10:51:39 +08:00

README.md

ULP ADC Example

This example demonstrates how to use the ULP coprocessor to poll ADC in deep sleep.

ULP program periodically measures the input voltage on GPIO34. The voltage is compared to two thresholds. If the voltage is less than the low threshold, or higher than the high threshold, ULP wakes up the system.

By default, thresholds are set to 1.35V and 1.75V, approximately.

GPIO15 is connected to ground to supress output from ROM bootloader.

Average current drawn by the ESP32 in this example (with the default 4x averaging) depending on the measurement frequency is as follows:

Measurement frequency, Hz	Average current, uA
10	8.5
50	20
100	37

Example output

Below is the output from this example.

Not ULP wakeup
Entering deep sleep

Deep sleep wakeup
ULP did 1531 measurements
Thresholds:  low=1500  high=2000
Value=973 was below threshold
Entering deep sleep

Deep sleep wakeup
ULP did 2 measurements
Thresholds:  low=1500  high=2000
Value=0 was below threshold
Entering deep sleep

Deep sleep wakeup
ULP did 2 measurements
Thresholds:  low=1500  high=2000
Value=0 was below threshold
Entering deep sleep