idf_component_register(REQUIRES bootloader) if(NOT BOOTLOADER_BUILD) idf_build_get_property(build_dir BUILD_DIR) if(CONFIG_APP_BUILD_GENERATE_BINARIES) partition_table_get_partition_info(app_partition_offset "--partition-boot-default" "offset") esptool_py_custom_target(app-flash app "app") esptool_py_flash_target_image(app-flash app "${app_partition_offset}" "${build_dir}/${PROJECT_BIN}") esptool_py_flash_target_image(flash app "${app_partition_offset}" "${build_dir}/${PROJECT_BIN}") endif() # If anti-rollback option is set then factory partition should not be in Partition Table. # In this case, should be used the partition table with two ota app without the factory. partition_table_get_partition_info(factory_offset "--partition-type app --partition-subtype factory" "offset") if(CONFIG_BOOTLOADER_APP_ANTI_ROLLBACK AND factory_offset) fail_at_build_time(check_table_contents "ERROR: Anti-rollback option is enabled. Partition table should consist of two ota app without factory partition.") add_dependencies(app check_table_contents) endif() # Generate flasher_args.json for tools that need it. The variables below are used # in configuring the template flasher_args.json.in. # Some of the variables (flash mode, size, frequency) are already set in project_include.cmake. set(ESPTOOLPY_BEFORE "${CONFIG_ESPTOOLPY_BEFORE}") set(ESPTOOLPY_AFTER "${CONFIG_ESPTOOLPY_AFTER}") set(ESPTOOLPY_CHIP "${target}") set(ESPTOOLPY_WITH_STUB TRUE) if(CONFIG_SECURE_BOOT OR CONFIG_SECURE_FLASH_ENC_ENABLED) # If security enabled then override post flash option set(ESPTOOLPY_AFTER "no_reset") endif() if(CONFIG_APP_BUILD_GENERATE_BINARIES) file(READ "flasher_args.json.in" flasher_args_content) string(CONFIGURE "${flasher_args_content}" flasher_args_content) file_generate("${CMAKE_CURRENT_BINARY_DIR}/flasher_args.json.in" CONTENT "${flasher_args_content}") file_generate("${CMAKE_BINARY_DIR}/flasher_args.json" INPUT "${CMAKE_CURRENT_BINARY_DIR}/flasher_args.json.in") endif() endif()