diff --git a/README.md b/README.md
index 819a796..eaa946c 100644
--- a/README.md
+++ b/README.md
@@ -29,6 +29,8 @@ I then try to reverse engineer the frames sent to control the Easylink system.
 - Control ESP via GPIOs
 - Control ESP via Serial connection
 - Reverse engineer of anti-theft / VIN protection calculation
+- Test microphone connection
+- Test AUX Line-In connection
 - CAN msg Full MUTE of Easylink
 - CAN msg for speed signal (for rising and lowering volume)
 
@@ -73,8 +75,61 @@ If you want to use USB devices, just grab a USB mini cable and try to plug it in
 
 A USB mini to OTG cable will work too, but you must test if the connector fits into the socket or modify it.
 
+## Microphone connection
+
+Not tested yet.
+
+## Aux Line In connection
+
+Not tested yet.
+
 # Pinouts
 
+Easylink power/speaker connector:
+
+PIN 2 = Front Left +
+PIN 3 = Front Left -
+PIN 4 = Rear Left +
+PIN 5 = Read Left -
+PIN 11 = Front Right +
+PIN 12 = Front Right -
+PIN 13 = Rear Right +
+PIN 14 = Rear Right -
+PIN 19 = +12V permanent
+PIN 20 = Ground
+
+Beware: Look at the numbers in the Easylink socket, my plug has wrong numbering !
+
+Easylink accessory connector:
+
+PIN 20 = EXT-CAN High (120 Ohms termination required)
+PIN 40 = EXT-CAN Low (120 Ohms termination required)
+PIN 19 = M-CAN High (Transreceiver and termination on these pins)
+PIN 39 = M-CAN Low (Transreceiver and termination on these pins)
+PIN 18 = M-CAN High (Termination here)
+PIN 38 = M-CAN Low (Termination here)
+
+PIN 1 = Mic 1 Signal
+PIN 2 = Mic 2 Signal
+PIN 21 = Mic Common Ground
+
+PIN 4 = Aux Detect (you can disable it within DDT)
+PIN 7 = Aux Line In Right
+PIN 8 = Aux Line In Left
+PIN 27 = Aux Ground
+
+PIN 12 = Ground for reversing camera
+PIN 13 = +6V for reversing camera (needs loaded with 300 Ohm to PIN 12, when using 12V camera)
+PIN 32 = CVBS differential + for reversing camera
+PIN 33 = CVBS differential - for reversing camera
+
+Touch display connector:
+
+PIN 15 = +12V permanent
+PIN 17 = Ground
+PIN 11 = M-CAN Low
+PIN 23 = M-CAN High
+
 ## Sourcing hardware
 
 ### Multimedia connector for power and speakers
@@ -96,7 +151,7 @@ HSD Cable for Easylink to touch display video connection, use the cyan one which
 
 https://de.aliexpress.com/item/1005005476955786.html
 
-Fakre to SMA antenna adapters for example, use the cyan ones which can plug into all sockets
+Fakra to SMA antenna adapters for example, use the cyan ones which can plug into all sockets
 
 # Programming with pyren, DDT4all, CLIP or something