From b549fd7b4d1ebfdbfac72884f3f69ad28a7065cb Mon Sep 17 00:00:00 2001 From: Ray Jones Date: Wed, 23 Jan 2019 09:13:19 +0000 Subject: [PATCH] Update Detailed Control Menu --- User-Manual/Menus/Detailed-Control-Menu.md | 9 ++++++--- 1 file changed, 6 insertions(+), 3 deletions(-) diff --git a/User-Manual/Menus/Detailed-Control-Menu.md b/User-Manual/Menus/Detailed-Control-Menu.md index bf4427c..19bf90c 100644 --- a/User-Manual/Menus/Detailed-Control-Menu.md +++ b/User-Manual/Menus/Detailed-Control-Menu.md @@ -35,12 +35,14 @@ Once the body temperature rises over about 65 degrees or so, the glow plug is sh The heater runs in this state for quite a few minutes getting the internals nice and hot. ![ScreenDetailedIgnitedGlowOff](uploads/e3eef473f0547203b173befd5a4b5ca7/ScreenDetailedIgnitedGlowOff.jpg) -After running at full speed for a while, the heater transitions to the running state, and now obeys the desired setting being ewither a thermostat setting, or a fixed heat demand. +After running at full speed for a while, the heater transitions to the running state, and now obeys the desired setting being either a thermostat setting, or a fixed heat demand. This happens about 5 minutes after the initial start was demanded: ![ScreenDetailedRunning](uploads/a2c11dbf0a7e39b00feabb583b80102c/ScreenDetailedRunning.jpg) To toggle from Thermostat or Fixed demand modes, hold the down key. -The changed operating mode is reflected in the units reported below the target icon. DegC for thermostat, Hz for fixed demand: +The changed operating mode is reflected in the units reported below the target icon. +DegC for thermostat, Hz for fixed demand. +The set temperature indicator also disappears from the left hand side thermometer when in fixed demand mode: ![ScreenDetailedFixedHz](uploads/14f7975a7e8751fd35313fc5343e5004/ScreenDetailedFixedHz.jpg) ## Stopping the heater @@ -52,7 +54,8 @@ The pump speed is quickly lowered and eventually shut off, the glow plug is gent ![ScreenDetailedShutdownLowPump](uploads/6c7390ad2fdb47585f775406c0a166ba/ScreenDetailedShutdownLowPump.jpg) ![ScreenDetailedShutdownPumpOff](uploads/a811eb45c5fa2dee814cdd65130bff4e/ScreenDetailedShutdownPumpOff.jpg) -About a minute later the glow plug is un-powered and the heater then transitions to cooldown mode: +About a minute later the glow plug is un-powered and the heater then transitions to cooldown mode. +Only the fan is now running: ![ScreenDetailedCooling](uploads/e191cc96a957d7d33b26b4983609bab4/ScreenDetailedCooling.jpg) It stays in cooldown mode until the heat exchanger is observed to have dropped below 55 degC, at which point it then returns to the initial idle state.